Prime Water Membrane filters

Prime Water membrane filters consist of a bundle of hollow fiber membranes in a tube, where the space between the membranes and the tube has been hermetically sealed with an epoxy resin. This is a very efficient design with no unused space in the cartridge, as is the case in helically wound cartridges.

The low pressure drop across the membranes enables a very compact construction and high flow rates at point of use applications.

Filtration techniques

Prime Water offers two filtration techniques:

  1. In the so called "Dead end" filtration technique (figure 1), the water flows from the outside to the inside and the filtered particles are caught in the porous membrane wall, which gradually clogs. A decrease in flow rate to an unacceptable level is a signal for replacement of the filter. This technique is primarily applied with micro-filtration membranes in the Legionella Safe Shower filters, In Line filters and Dual Stage filters.
  2. In the so called "Forward flush" technique (figure 2), the water flows from the inside to the outside, retaining the filtered particles, as well as bacteria and viruses, on the inside of the membrane. This technique allows reversal of the flow and flushing of the membranes from the outside to the inside with filtered water, while disposing of the dirt from the bottom of the cartridge.

Purification Standards:

The Prime Water Membrane filters meet the highest purification standards, for example the US EPA standard and protocol for microbiological water purifiers.

Service Life

As a result of the broad and unpredictable variations in the nature and concentration of microparticles in the water, the service life of a "dead end" membrane filter will depend on local water conditions and the presence of pre-filtration. The service life of a "dead end" membrane filter can be assessed by measuring the concentration of microparticles by means of the SDI (Silt Density Index) method.